trv calibration via remote thermostat and firmware upgrade

LightwaveRF Communi… > Forum > Future Products > trv calibration…

LightwaveRF Community: Welcome Forums Future Products trv calibration via remote thermostat and firmware upgrade

This topic contains 1 reply, has 2 voices, and was last updated by  skiv71 3 years, 10 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #17829
     commer7281 says:

    commer7281
    Participant

    As the trvs operate off its own stat, which can be several degrees out due to position relative to where the ambient heat is required, how about an update that lets you calibrate them to allow for the tolerance so you get a truer “room” temperature by having a calibration mode where the boiler remote stat is placed in the room where the temperature should be stable and this communicates with and calibrates the tolerances in to the trvs?

    #17831
     skiv71 says:

    skiv71
    Participant

    I think they’d much rather you put a stat in each room too :)

    developer of BMS Link (http://linode.bmslink.co.uk). A cloud based Home Automation platform for LightwaveRF, Z-Wave, RFXCOM.
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.