Mood on Master Switch doesn't seem to work when I set it up

LightwaveRF Communi… > Forum > Installation and… > Mood on Master Swit…

LightwaveRF Community: Welcome Forums Installation and Troubleshooting Mood on Master Switch doesn't seem to work when I set it up

This topic contains 0 replies, has 1 voice, and was last updated by  Johnny T 2 months, 3 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #24022
     Johnny T says:

    Johnny T
    Participant

    Hi there,
    I’ve just bought a master switch. I’ve paired it with two double sockets (i.e. 4 sockets).

    “All on” and “All off” are working perfectly.

    I would like to set one of the mood switches so that I can have 3 sockets on but 1 socket off.

    I have set up the sockets to this state and then press and hold Mood 1 switch expecting the blue light to flash and remember this setup.

    However, when I press the Mood 1 switch, the blue light just stays on (pressing and holding the switch for 20 seconds or more).

    This is the same for either Mood 2 or Mood 3 as well?

    Any ideas why it’s not accepting a “Mood” setup??

    Thanks for any help you can give me.

    :)

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.