Mixing 200 and 400 series switches

LightwaveRF Community: Welcome Forums General LightwaveRF Discussion Mixing 200 and 400 series switches

This topic contains 0 replies, has 1 voice, and was last updated by  davew21 3 weeks, 6 days ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #24508
     davew21 says:

    davew21
    Participant

    I’ve posted a couple of questions else where on here as I have issues with a slave switch (killed 2 so far) had them for ages so can’t return under warranty, ordered a replacement but a 400 series slave has arrived and i have a 200 series master, is there a combination that does work or is mixing in any form a no-no, I did test the slave today at work with a spare 200 series master and it seemed to work ok but I was only using an ordinary filament lamp, I’m going to take the offending LED lamp with me tomorrow to see if the same happens again, LED lamp works fine with just the master but as soon as you attach the slave switch funny things happen then the slave dies (see my other post).

    Thanks

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.