LW821 stopped 'switching' after power cut

LightwaveRF Communi… > Forum > Installation and… > LW821 stopped &#039…

LightwaveRF Community: Welcome Forums Installation and Troubleshooting LW821 stopped 'switching' after power cut

This topic contains 0 replies, has 1 voice, and was last updated by  Matt 2 months, 3 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #34303
     Matt says:

    Matt
    Participant

    Inline LW821 sat in the hall, working two LEDS outside lovely for two weeks. All wired up and worked fine with Gen2 Linkplus.

    Till we had a small power interruption.

    Now the LW821 won’t make the ‘switching’ click when pressed on etc app (although app reports that LW821 is ‘on’) and no change to the LEDS.

    Most annoying. Have gone through reset (press button three seconds lights flash, relink to Gen 2 Linkplus, ) but no good.

    Now can’t remotely operate the leds, as the LW821 is mounted in the wall behind plate…! and need to get working.

    Have re powered again, reset router, repowered Linkplus, all the usual. But won’t operate… what to do?

    Matt

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.