Dimmer failed after an hour

LightwaveRF Communi… > Forum > Installation and… > Dimmer failed after…

This topic contains 0 replies, has 1 voice, and was last updated by  jackregan 2 months, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #24025
     jackregan says:

    jackregan
    Participant

    Hi… any help appreciated:

    I bought a master dimmer (single) switch and installed it in place of my kitchen light switch. It’s the only switch for those lights, so just the blue and brown wires. So, all simple so far. I should point out though (in case it matters) that I was replacing a non-dimmer with a dimmer. Should be fine though as the bulbs *are* dimmable.

    Anyway, it worked fine for an hour and then just failed. First of all the blue LED went on without it actually turning the lights on, and then it just went dead.

    I tried tightening the wires. Basically, I tried everything I could think of.]

    Any thoughts? Did I make a basic error somewhere? Or is it just a dud unit?

    Thanks in advance.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.