Car ALARM with magnetic switch JSJS LW904

LightwaveRF Communi… > Forum > Future Products > Car ALARM with magn…

LightwaveRF Community: Welcome Forums Future Products Car ALARM with magnetic switch JSJS LW904

This topic contains 3 replies, has 2 voices, and was last updated by  hongkong 3 years, 9 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #18302
     hongkong says:

    hongkong
    Participant

    Hi guys I use LWRF few months and I like it.
    The only problem I had was power meter as here in
    Slovenia and many countries like Italy we have 3 phase
    cable entering our houses or flats. And with Power meter
    RF we get only one clamp. I ask technicians where is possible to
    purchase and shame they reply no way. Very big shame of such
    a company.

    Another my idea was and tested to place remote magnetic switch
    Model JSJS LW904
    I place it under the hood and another on driver door and its work
    very well with one lamp and buzzer at corridor.

    Thieves forget that old frequency range is very reliable and good
    better than GSM. You can also place switch on garage door, main
    garden doors ect…

    I also place green plastic transparent light tape over the
    main Wifi LInk as by night DIMM is not good its disturbing too
    much light if you have it in sleeping room.

    Attachments:
    You must be logged in to view attached files.
    #18304
     hongkong says:

    hongkong
    Participant

    Magnetic switch

    Attachments:
    You must be logged in to view attached files.
    #18309
     mmcnamee says:

    mmcnamee
    Participant

    Hi,

    I’m pretty sure the energy monitor (certainly version 1) actually had 3 inputs in the bottom, but only one was accessible and they only provide one clamp point.

    If they said it can’t read 3-phase then you’re out of luck, but I don’t understand why they’d produce the case with 3 knockouts for inputs then only allow one to be used!

    #18364
     hongkong says:

    hongkong
    Participant

    Yes I tried with all 3 inputs and snap plastic on box and work fine but when I asked where is
    possible to purchase another additional 2 clamps they reply Not possible !!!

    What are company is this? Why 3 inputs than? Most of Europe
    have 3 phases cable in flats houses ect…

    Did someone sell 2 add clamps? Now I have readings only from 1 Phase what
    is sucks.

    Green tiny plastic inside is wonderful.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.