Advice on removing GU10 light fittings

LightwaveRF Communi… > Forum > The Lounge > Advice on removing…

LightwaveRF Community: Welcome Forums The Lounge Advice on removing GU10 light fittings

This topic contains 1 reply, has 2 voices, and was last updated by  Chester 1 year, 8 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #21207
     ukmgranger says:

    ukmgranger
    Participant

    I have 9 ceiling mounted GU10′s in the kitchen, and I want to remove two of them as I’m going to add some other form of lighting (Using Lightwave) instead.

    Can I just remove the transformers, terminate the wires into a junction box and plaster over the holes? Or would this be a bad idea?

    Just to note – I don’t need to use the existing wiring for the new lighting I’m putting in, as this is entirely separate.

    #21214
     Chester says:

    Chester
    Participant

    GU10 with transformers? Surely they’re MR16s.

    Personally I’d take out the cables that run between the two lights and their neighbours, and run a single cable between the neighbouring lights instead. Much neater.

    Chester
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.